If your ice maker has gone quiet — no cubes, slow production, or a frozen-over evaporator — you don't need to order online and wait a week. Edmond is right on our doorstep, and most of the ice maker parts you need are already on the shelf at the Piedmont shop. We stock water inlet valves, ice maker modules, harvest forks, control boards, water line tubing, and more for Whirlpool, Frigidaire, GE, Samsung, and Scotsman machines. The YAP Dude can usually identify your exact part from the model number alone, so grab that off the inside wall of the ice maker compartment before you head over.
Common Ice Maker Parts We Stock
Water Inlet Valve
Evaporator
Ice Maker Module
Water Line Tubing
Control Board
Harvest Fork
Common Ice Maker Problems We Fix
No water filling the ice mold
A failed water inlet valve is the most common culprit. This solenoid-controlled valve cuts off water flow when it burns out, and a replacement typically runs under $40.
Ice maker cycles but drops no cubes
The harvest fork (also called the ejector arm) can crack or strip, leaving cubes stuck in the mold. Swapping the harvest fork is a straightforward fix most people handle in under 20 minutes.
Frozen evaporator or ice bridge build-up
A weak defrost cycle lets frost coat the evaporator, blocking production. Depending on your model, the fix may be a new control board or a defrost thermostat.
Ice maker module not initiating a cycle
The ice maker module controls timing and motor function. When it fails, the whole unit sits idle — a direct module replacement usually restores normal operation.
Leaking water behind the refrigerator
Cracked or kinked water line tubing is almost always the source. We carry replacement tubing in the right diameter for most brands so you can re-run a clean line.
Ice maker runs but produces tiny or misshapen cubes
Low water fill is usually the cause, pointing back to a partially clogged water inlet valve or low line pressure. A new valve and a pressure check will sort it out.
Have your model number? Find the exact part.
Type your appliance's model number into our part finder — we'll search every major supplier and pull the genuine OEM part in seconds.
“I was not certain how to go about getting parts for my oven that had failed about 2 months ago and I was stressing out over how to get the parts for an oven that I hadn’t seen locally. Thankfully YAP in Piedmont was there to save the day. Morgan was very helpful and even called …”
Do you carry ice maker parts for Samsung French-door refrigerators?
Yes — Samsung is one of the brands we specifically stock for, including the ice maker modules and water inlet valves notorious for failing in their French-door models. Bring your full model number and we'll pull the right part.
How far is the drive from Edmond to your Piedmont shop?
You're looking at about 18 minutes. Head west on Memorial Road, south on NW 178th, then west into Piedmont — it's an easy shot and beats waiting days for shipping.
Can I get the part number before I make the drive?
Absolutely. Text your model number to 405-876-8100 and the YAP Dude will look up the part and confirm we have it in stock before you leave the driveway.
My Scotsman commercial ice maker is down — do you stock commercial parts?
We carry Scotsman parts for both residential and light-commercial units, including harvest forks, control boards, and water inlet valves. Call or text ahead for commercial models so we can confirm availability.
Is it worth repairing an ice maker or should I just replace the refrigerator?
In most cases, repair wins — ice maker parts are relatively inexpensive and the job is DIY-friendly. If the compressor or sealed system is also failing, that's a different conversation, but a bad module or valve is almost always worth fixing.
Ice maker down and you need it fixed today? Edmond customers are never far from a solution. Text your model number to 405-876-8100 and we'll have your part ready, or just walk into the Piedmont shop — we're 18 minutes away and the part is likely already on the shelf.
